| Περιγραφή: |
При построении сорбционной метаноёмкости пласта используется зависимость Ленгмюра, связывающая удельную массу метана, содержащуюся в единице объёма угля, и поровое давление метана. Коэффициенты, входящих в эту зависимость, находятся из решения системы уравнений после определения значений удельной массы метана в двух разных местах пласта. Для этой цели из забоя выработки бурится контрольная скважина, и из неё производятся замеры параметров метана (начальной скорости газовыделения и давления в ней) при двух разных её глубинах. Начальная скорость газовыделения определяется с помощью расходомера, а для замеров давления предлагается использовать не герметизатор, а цилиндрическую оболочку, в которую поступает метан из скважины. Материал оболочки принимается с низкими характеристиками жёсткости. Деформация оболочки под действием избыточного давления метана связана с её геометрическими и физико-механическими параметрами известными формулами теории оболочек. Зная измеренную деформацию, легко определить избыточное давление метана и, следовательно, подсчитать удельную массу метана в скважине в двух её сечениях и после этого определить коэффициенты уравнения Ленгмюра. In constructing the sorption methane reservoir, the Langmuir dependence is used, which binds the specific mass of methane contained in the unit of coal volume and the pore pressure of methane. The coefficients included in this relationship are found from the solution of the system of equations after determining the values of the specific mass of methane in two different places of the formation. For this purpose, a control well is drilled from the bottomhole, and methane parameters (initial gas release rate and pressure in it) are measured from it at two different depths. The initial velocity of gas release is determined using a flowmeter, and for pressure measurements it is proposed to use not a sealer, but a cylindrical shell, which receives methane from the well. The material of the shell is accepted with low stiffness characteristics. Deformation of the shell under the action of excessive pressure of methane is associated with its geometric and physico-mechanical parameters by known formulas of shell theory. Knowing the measured deformation, it is easy to determine the excess pressure of methane and, therefore, calculate the specific mass of methane in the well in its two sections and then determine the coefficients of the Langmuir equation. |